Through education, enforcement, and outreach, pedestrian safety programs are directed toward reducing pedestrian injuries and fatalities. Walking is encouraged as an alternate mode of transportation to motor vehicle travel. Additional goals include: reducing the number of impaired pedestrian injuries and fatalities, improving the safety of elderly pedestrians and reaching diverse communities.
Because walking is such a routine part of everyday life, many people do not consider the safety aspects of walking. For instance, most injuries to walkers happen when a vehicle hits them because the driver could not see the walker or the walker and driver were not paying close enough attention.
According to FS 316.130(7)(b) The driver of a vehicle at any crosswalk where signage so indicates shall stop and remain stopped to allow a pedestrian to cross.
The key to remember is to See and Be Seen . It is a good idea when walking, especially at dawn, dusk, and other low-light conditions, to wear light colors or bright clothing so that you can be easily seen. Fluorescent colors such as blaze orange, hot pink, and day-glow green are ideal in daytime but not at nighttime.
To See and Be Seen, keep in mind that:
- Intersections are especially difficult for older pedestrians. You are most at risk when first stepping off the curb, because drivers may not see you until you’re actually in the roadway. Always stop at the curb and look left, right, and then left again for cars before entering the roadway. Don’t assume the drivers see you unless they signal for you to cross.
- Turning vehicles can be especially dangerous at intersections. Drivers are concentrating on making their turns and avoiding oncoming traffic, so they might not see you! Exaggerate your head turns so that you look in all directions, including behind you. Make sure you look for vehicles making right turns on red and for vehicles making left turns. Always make sure the driver of a vehicle that is turning sees you.
- Understand crosswalk signals. The flashing DON’T WALK signal, like the yellow caution light, means that you shouldn’t start to cross the street. However, if you are in the street when the signal begins flashing, don’t stop or return to the curb. Continue to walk as fast as you can, comfortably, until you reach the other side or a pedestrian island. Some areas are using a new WALK signal that counts down the seconds remaining for you to cross the intersection safely. When the seconds run out, a steady DON’T WALK light will come on because the traffic light is about to change.
- Walk with a friend. Walking with a friend will add to the pleasure of your walk and increase your safety as well, as long as you are watching out for each other. Enjoy your conversation, but don’t let it distract you from watching out for road and traffic hazards as you walk.
A Matter of Life and Death: 20 mph versus 40 mph
- A little slower speed can mean a world of difference for pedestrians and bicyclists. Pedestrians hit by a car traveling 40 mph have a mere 15 percent chance of survival. At 30 mph, those odds increase to 45 percent. By contrast, a pedestrian has an 85 percent chance of survival if hit by a car moving at 20 mph.